Filtration efficacy

Our filtering face piece respirators can be used for respiratory protection against various non-oily airborne contaminants.  They are extremely effective (94-99%) against tiny particulate matter of less than 0.3 and 2.5 microns in diameter (PM0.3 and PM2.5 respectively) among which are many infectious agents. For the purpose of protecting yourself from influenza viruses (SARS, avian flu, coronavirus, etc.), respirator masks were recommended as part of the PPE by the World Health Organization (WHO).

100% compliant with regulations (CE, FDA, EN 149:2001+A1:2009)

Our FFP2 respirators have been confirmed to meet all of the performance requirements set by the European Standard EN 149:2001+A1:2009. They are also completely CE-certified and FDA-cleared. Please note that if you need reassurance regarding the certification of our products, we are willing to send you the copies of the relevant documents upon request!

Non-reusable (NR)

In order for your FFP2 particulate respirator to effectively protect you from the particulate matter you should wear it for a maximum of four to five hours. Please do not share your mask with other people. If your respirator mask becomes damaged or dirty, throw it away. Please follow our instructions for proper user seal checks before each use.

Folded Design

You can easily carry around our folded masks in your pocket or your purse. Convenient as they are, they might be the right choice to have on you at all times. Just store them in a clean plastic bag and you’re good to go! But be careful to put them on tightly and not leave any gaps between your face and the mask. If you’re looking for a design that is less likely to have leakage, check out our cupped design masks.

Non-valved Respirator Mask

Non-valved FFP2 masks offer a two-way protection. Our respirator masks will be effective whether your goal is to avoid inhaling the virions, or avoid spreading the virus to people close to you. A mask without a valve is also less bulky, presenting a more lightweight solution. If, however, you are looking for more breathability, feel free to check out our valved masks.

[User Seal Check]

Before entering a possibly contaminated area, you need to properly put on your filtering face piece. To do this you need to:

  1. Take the mask in one hand so that the nose clip is turned upwards.
  2. Place the bottom of the mask against your chin, while using your other hand to pull both straps over your head. The bottom strap should go below your ears over your neck. The top strap should go high on your head, above the ears.
  3. Adjust the mask carefully against your face, not allowing for any gaps between the mask and your face.
  4. Adjust the nose clip with both hands to ensure the nose clip is firmly tightened. Pinching it with just one hand is not advised as it might affect the tightness of the mask.
  5. Finally, check if you completed all of the steps correctly by putting both of your hands over the mask so as to not affect its position, and then quickly exhaling. Depending on where you fill the air passing, adjust the nose clip or the entire mask accordingly, following the aforementioned steps. If there are no gaps for the air to pass through, you have correctly put on the mask.